1.With the engine running, set the A/C controls to maximum position.

2. Attach the appropriate hose with a retracted piercing valve to the installation can then SHAKE WELL.

3.Attach the other end to the suction port and loosen can slightly to remove air.

4. Quickly re-tighten can and turn the can upside down (valve down).

5. Puncture the can by twisting the piercing valve handle then back out the piercing valve to open the valve to allow the contents to flow into the system. Allow 1-2 minutes for installation. Continue to shake.

6.Close the piercing valve and remove the hose from the suction port. Replace suction port cover.

7. Leave the empty can attached to the hose to prevent contamination of hose. The installation is complete.

If you are installing into a dual evaporator system you will need to install 2 cans to get the proper amount for the system.

Drive the vehicle for 150 miles to allow the treatment process to fully complete.

Caution: Keep out of children’s reach. Always wear protective eye wear and gloves. Keep hands away from hot surfaces and all moving parts such as fan blades, belts, pulleys etc.

Contains petroleum distillates.

Harmful if swallowed. Do NOT induce vomiting. Call Physician immediately